输液滴速计算

🧮 IV Drip Rate Calculator

Convert a prescribed infusion volume and duration into drops per minute and millilitres per hour for a given drop factor, with a rounded practical setting suggested.

📐 计算公式与说明

输液滴速:总滴数 = 液体总量 × 滴系数;滴速 = 总滴数 ÷ 时间(滴/分);秒/滴 = 60 ÷ 滴速。校验:三项非空守卫,空值按 0 兜底。判据:无固定分级,滴系数由输液器规格决定(常用 15/20 滴/mL),时间越短滴速越快。

临床需根据患者情况调整。

Formula & Standard References

Item Formula / Note Source / Standard
Drip rate formula drops per minute is volume times drop factor over total minutes ISO 8536-4:2019, infusion equipment
Drop factor the drop factor comes from the set and is commonly fifteen or twenty per millilitre ISO 8536-4:2019, infusion equipment
Double check high alert infusions need a double check of rate and volume ISO 15189:2022, medical laboratories

📚 深度解析:输液滴速计算

💡 常见使用场景

方法
算法:总滴数 = 液体量(mL) × 滴系数(gtt/mL);滴速 = 总滴数 ÷ 时间(min);秒/滴 = 60 ÷ 滴速。要求各值>0。滴系数常见 15/20 gtt/mL。
算例
例1(500mL / 120min / 滴系数 20):总滴数 500×20 = 10000 滴,滴速 10000/120 = 83.3 滴/分,约 0.72 秒/滴。例2(1000mL / 240min / 滴系数 15):总滴数 15000 滴,滴速 62.5 滴/分,约 0.96 秒/滴。

❓ 常见问题(FAQ)

滴系数怎么定?
由输液器规格决定(常见 15、20 gtt/mL,精密输液器不同),滴速按所用输液器系数计算;按说明书或护理规范设置。
滴速算出来但要调慢?
心肾患者常需更慢;计算值是医嘱时间对应的理论滴速,实际须按患者耐受与医嘱调整,并定时巡查。