瞳高定位器

👓 Pupil Height Locator

Locate the binocular pupil height (segment height) for multifocal lens fitting.

📐 计算公式

瞳高定位(本页代码口径,双模式):直接测量法 瞳高=瞳孔中心至镜框下缘读数(mm)、占比=瞳高÷B 值×100(%);公式计算法 瞳高=B 值−瞳孔到上缘距离,占比同式。校验:直接法瞳高 ≤0 提示无效;计算法 B 值或上缘距离 ≤0 提示无效、上缘距离>B 值提示「不能大于镜框B值」。判据:占比 <50% 偏低(光心偏上)、>70% 偏高(偏下)、50%–70% 正常;渐进适配 <14mm 不满足最低要求、14–18 短通道、18–22 标准通道、22–30 长通道、>30 偏大注意远用区。

比例 50%–70% 为光学中心位置正常;偏低光学中心偏上、偏高偏下,影响装配与视觉质量。

直接测量法:让佩戴者自然平视,用瞳高尺测量瞳孔中心到镜框下缘沟槽的垂直距离。
22mm

📋 瞳高参考标准

镜片类型最小瞳高 (mm)理想瞳高 (mm)说明
单光镜片无限制—瞳高对单光片影响小
渐进短通道1416-20适合小镜框
渐进标准通道1820-24常规镜框
渐进长通道2224-28大镜框,适应性好
抗疲劳镜片1416-20下加光0.50-0.75D
瞳高过小会导致渐进镜片近用区被截断,阅读视野不足;瞳高过大则远用区缩小。一般瞳高占镜框B值的55%-65%为宜。
瞳高测量需在镜架实际佩戴调整后进行,建议使用瞳距仪或数码定位系统精确测量。

📚 深度解析:瞳孔高度测量

💡 常见使用场景

  • 渐进/双光片需测单眼瞳孔高度。
  • 定光学中心垂直位置。
  • 装配前标记与复核。
测量
镜圈下缘到瞳孔中心 22mm、通道 17mm → 近用区中心 22−17=5mm,标记后装配光心对齐。
误差影响
瞳孔高差 2mm 致渐进通道偏,阅读区上移/下移造成「看不清近」或头晕,须重测。

❓ 常见问题(FAQ)

单眼都要测?
要。脸不对称使左右瞳孔高不同,尤其渐进片,均分会导致一侧不适。
和瞳距一起测?
是。水平(单眼 PD)+ 垂直(瞳孔高)共同定位光学中心,缺一不可。

Formula & Standard References

Item Formula / Note Source / Standard
Definition of pupil height The vertical distance from the pupil centre to the lower inner rim of the frame ISO 8624:2011, Ophthalmic optics - Spectacle frames - Measuring system and terminology
Fitting requirement Fitting height must place the distance zone above and the near zone below the pupil ISO 8980-2:2017, Uncut finished spectacle lenses - Part 2: Progressive power lenses
Consequence of insufficient height Too low a fitting height cuts off the near zone and makes near vision unusable ISO 8980-2:2017, Uncut finished spectacle lenses - Part 2: Progressive power lenses
Matching the corridor Check the fitting height together with the chosen corridor length and minimum fitting height ISO 8980-2:2017, Uncut finished spectacle lenses - Part 2: Progressive power lenses
⚠️ 使用说明与注意事项
📖关于「瞳高定位器」 ▼

工具简介

计算瞳孔中心到镜框下缘的垂直距离(瞳高),评估是否满足渐进多焦点镜片的定位要求。

功能特点

使用场景

📖关于「瞳高定位器」 ▼

📝工具简介

瞳高定位器,计算瞳孔中心到镜框下缘的垂直距离,用于渐进多焦点镜片佩戴定位与安全范围评估。。医疗专业工具,基于权威医学标准,仅供参考。

✨功能特点

🎯使用场景